TENSA-COMPRESS-A-mainimg

Rubber compression joint

TENSA-COMPRESS A

product_logo_expansion-joints

신축이음장치

Principle

TENSA-COMPRESS A movement joint profile is a compression profile that can be used to facilitate movements of up to 65 mm at a maximum gap width of 120 mm. The TENSA-COMPRESS A profile, which is glued into position in a state of pre-compression, allows longitudinal, transverse and vertical movements of the structure. The design of the internal ribbing ensures lasting dimensional stability in all positions. The TENSA-COMPRESS A movement profile offers high resistance to de-icing salt, UV radiation, ozone and mechanical damage.

Applications

TENSA-COMPRESS A movement profile is designed to accommodate movements, and seal trafficable joints and gaps, in bridges, ramps, parking decks, industrial flooring and so on. It can be inserted into recesses cut into concrete slabs, or into steel or epoxy edge constructions. Depending on the design of the edge structures at each side, TENSA-COMPRESS A is suitable for small or large loads, and can be used in curves or in structures with a slope.

TENSA-COMPRESS-A-img1

Joint along wall

TENSA-COMPRESS-A-img2

As used in a car park

TENSA-COMPRESS-A-img3

Detail at kerb

TENSA-COMPRESS-A-img4

Sealing joint between wall and ceiling

TENSA-COMPRESS-A-img5

Seals at floor-wall joint

TENSA-COMPRESS-A-img6

Sealing balcony slabs

TENSA-COMPRESS-A-img7

Sealing a structural joint