Tél: +41-44-872 40 50
The Delaware Memorial Bridges is a twin suspension bridge crossing the Delaware River. The toll bridges carry Interstate 295 and U.S. Route 40 between Delaware and New Jersey.
It is one of only two crossings of the Delaware River with both U.S. Highway and Interstate Highway designations, the other being the Benjamin Franklin Bridge.
Scope of this project was to replace the existing pin & links, with modern uplift spherical bearings which offer lower friction as well as a robust uplift restraint.
In 2019 mageba supplied sixteen RESTON®SPHERICAL bearings, designed to resist frequent service limit state uplift loads of up to 302 kips (1,344 kN).
All bearings are equipped with modern structural health monitoring system, comprising of embedded pressure sensors, tiltmeter, displacement sensor and proximity sensors, that measure the load, rotation, movement and wear of sliding material respectively. The monitoring system is accessible 24/7 by the owner, through a user friendly web interface.
A full scale production bearing was tested to 150 % proof tension load, as well as
cyclic tension compression loading to simulate the frequent uplift load case.
In November 2020 mageba installed two flexible plug expansion joints to replace some of the aging and damaged strip seal joints on the bridge.
The project team is discussing the next steps coming up during the installation of the POLYFLEX plug expansion joint
Installation of the POLYFLEX plug expansion joint on two lanes at a time allowing traffic to remain flowing on the other two lanes of the bridge
TENSA®POLYFLEX® Advanced PU flexible plug expansion joints, RESTON® SPHERICAL bearings with up-lift control
Bearings equipped with Structural Health Monitoring System
2,150 ft. (655 m)
10,765 ft. (3,281 m)
Delaware River and Bay Authority
American Bridge Company