Oakland Airport Connector_mainimg

Estados Unidos

Oakland Airport Connector

Project description

Oakland International Airport, one of the key transportation hubs in the Bay Area of northern California, is now connected to the Bay Area Rapid Transit (BART) network by a new Automated People Mover (APM) system. The system features Doppelmayr cable-car technology, delivering passengers along the 3 miles (5.1km) track in just 8 minutes. The system will be fully automated, driverless and all-electric.

The cost of the project has been estimated at $492 million. California-based Flatiron/Parsons Joint Venture won the contract to design and build the system, and Doppelmayr Cable Car, Inc. won the contract to operate and maintain the system once built.

Delivered products

mageba supplied 775 elastomeric bearings for the elevated structure, supporting the steel guideway above its concrete columns. The bearings are of Type C in accordance with EN 1337, and thus have steel reinforcement plates at the core, and external connection plates on the upper and lower surfaces. The connection plates are vulcanised into the elastomer (a neoprene mix) of the bearing, and thus securely connected. They have threaded holes for easy bolting to the structures above and below, preventing sliding and allowing resistance to horizontal movement to develop. The use of this type of bearing therefore permits some elastic movement, providing a damping effect to the supported system.

REFSHEET-Oakland-Airport-Connector-img1

Rigorous testing of the APM system, including bearings, was carried out on a special test track.

REFSHEET-Oakland-Airport-Connector-img2

View of four LASTO-BLOCK elastomeric bearings at one pier.

Puntos destacados

Products:

775 LASTO-BLOCK elastomeric bearings

Features:

Steel fixing plates

Installed:

2012

City:

Oakland, California

Structure:

Railway viaduct

Completed:

2014

Length:

5.1 km

Contractor:

Flatiron/Parsons JV